How to Make a Homemade Room Heater For House using Old Tin Canister: First of all thanks for landing this article, if you are pointed for Homemade Room Heater For House. I just tell you are in the right place. So without getting into query lets directly jump into the post of Make a Tin Canister Heater in House.
The winters have started. In this case, everyone keeps the room heater in the house. But there is no need to buy a room heater to keep in the house. Do you know that you can make a room heater with luggage in the house? For this, you need a Tin Canister.
The tin can be found in your house only. To make a room heater, you will need the accessories given below.
- Tin canister
- Scale dividers and pen for measuring
- steel pipes
- M seal
- 38cm aluminum wire
- Cardboard 10 cm
- Double sided tape
- Silver coating spray
- Room Heater Road
- Normal tape
- Electric Wire
How to Make a Homemade Room Heater For House using Old Tin Canister:
Take the rhythm for this.
With the help of scale on the corner of the tin, mark 9 cm mark.
Now pull the line from top to bottom. This must be done on both sides.
Now cut the box with the help of cutter (where the marks are there). After cutting it will come in the shape of the heater.
Now take a steel pipe and make two pieces of 4 cm in it.
Apply M seal in the corner of both pieces of steel and apply it in the middle of the bone cut.
Now, the tin which has survived, pinching it in the corner, cut into 180 degrees i.e. half-round (half-circular) shape. In this figure, measuring the rump with a corner, two pieces of thorns
Then take the aluminum wire and remove its cover. You need to heat it to remove the cover. Tell you that this wire should be 38 cm.
Plate the aluminum wire in the pieces cut into pieces. Paste them in a little distance. You can see how to do this, you can see it in the given photo.
Turn the wire from both sides in the same way as shown in the picture.
This heater cover will be ready.
Take a cardboard and cut it into the crescent-shaped size. Along with it, the cardboard stand is also to be made.
Paste the double-sided tape on the three corners of the cardboard.
Now stick it to the corner of the tin.
Now spray the silver coating on the inside and outside of the ribbon.
After that take the room heater road and attached the wire to the wire.
Now remove the wire from both sides of the steel pipe and fit it in between. Paste the remaining wire back to the tape.
Now paste the outer part made of aluminum wire with the help of tape.
Now stick the cardboard stand in both corners.
Attach the electric wire to the rear wire and paste the tape.
Now plug the wire in or plugin with direct power. The road started to burn. Your room heater is ready.
Finally, I hope guys you understand “How to Make a Homemade Room Heater For House using Old Tin Canister” very useful. If you enjoyed this post, please leave a comment below and share it with your friends and followers on Facebook and Twitter.